ND-70348 (E) CHAPTER 4
Page 372
Revision 3.0
AICD_T
AICD_T: Assignment of Intercom Data – Telephone Number
1. General
This command is used to assign the data related to the Automatic/Manual Intercom service feature. The station
data of AICD command can be assigned by using Telephone Number instead.
2. Precautions
1. Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the
ALGSL command is not available in this command.
2. In case logging in to a LN, only the Telephone Numbers allocated to the stations within the logged-in
node can be used in this command. Also, when logging in to the NCN, the data memory of the whole
nodes in the network can be written.
3. Up to 16 stations may be assigned to one Intercom group.
4. Only
D
term
(s) can have the Automatic/Manual Intercom service feature applied.
5. A maximum number of Intercom groups within a Module Group (MG) is 50 groups, and each group is
given a unique Group ID Number (G-ID).
6. Prior to this command, ASYD command, SYS1, INDEX59, bit7=1 (Automatic/Manual Intercom is in ser-
vice) is required.
7. After the appropriate data has been assigned by this command, assign the AKYD command as follows:
KYI=2, KD=1, ICM=0 (Automatic Intercom key)
KYI=2, KD=1, ICM=1 (Manual Intercom key)
If the SIG key is required for Manual Intercom service feature, KYI=1, FKY=60 (Manual Signaling key).
8. The applicable Tenant Number (TN) range is designated by the ASYD command, SYS1, INDEX 8.
9. When you delete an Intercom member station away from the intercom group, you must first delete the
data assigned by the AKYD command. Then you may delete the data assigned by this (AICD_N) com-
mand.
10. An Intercom member can override another Intercom station in a two-party Intercom connection. This kind
of overriding is referred to as INTERCOM BRIDGE.
11. This command is available since Release 8 software enhancement.
To Next Page
Loading...
Need help?
General