ND-70348 (E) CHAPTER 4
Page 350
Revision 3.0
AKYD_T
AKYD_T: Assignment of Key Data for D
term
– Telephone Number
1. General
This command assigns the Line Key, Function Key, Intercom Key, and DSS Key data corresponding to each
line/feature button on a D
term
. The station data of AKYD command can be assigned by using Telephone Num-
ber.
2. Precautions
1. This command is available for software Release 9 or later.
2. Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the
ALGSL command is not available in this command.
3. In case logging in to a LN, only the Telephone Numbers allocated to the stations within the logged-in
node can be used in this command. Also, when logging in to the NCN, the data memory of the whole
nodes in the network is to be written.
4. Prior to this command, Telephone Numbers must be allocated by using the ALGSN command. Only the
Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the ALGSL
command is not available in this command.
5. The D
term
65 (16-button type) and D
term
75 have the default key data. (Refer to Precautions 8.) If the
default data is to be used, assignment in AKYD/AKYD_T is not necessary. The table below shows the
specification pertaining to data assignment for the D
term
.
Table 4-14 Data Assignment for the D
term
6. Before assigning the key data for a D
term
using this command, be sure to assign the station data of the
D
term
using the ASDT command (TN, STN, TEC = 12 (D
term
)). The station number assigned by the
ASDT command is referred to as “MY LINE”.
Note
Note: This “MY LINE” corresponds to the physical port associated with the LENS of a ELC card.
7. By assigning another station line to a feature button using this command, an incoming call terminated to a
station line other than My Line can be answered or can be transferred to elsewhere as in the case of the
My Line. A station line other than My Line is referred to as a “Sub Line.” A “Sub Line” can be assigned
not only to a D
term
but to any conventional telephone. In addition, the station data for My Line and Sub
Line must be assigned by the ASDT command before the key data is assigned. When the Sub Line and the
My Line belong to different tenants, use the ATNR command and clear the “Tenant-to-Tenant Restric-
tion.”
8. A Multi-Line key (the key for My Line and Sub Line) on the D
term
can be assigned as Prime Line. If the
Prime Line is not assigned, the My Line serves as the Prime Line. When the user goes off-hook, the Prime
Line is automatically selected on the D
term
.
TYPE OF D
term
LINE/FEATURE BUTTON NUMBER OF BUTTONS
D
term
65
8-button type KYN = 1-8 8
16-button type KYN = 1-16 16
24-button type KYN = 1-24 24
D
term
75
8-button type KYN = 1-8 8
16-button type KYN = 1-16 16
32-button type See Figure 4-9 32
To Next Page
Loading...
Need help?
General