ND-70348 (E) CHAPTER 4
Page 741
Revision 3.0
AANP
AANP: Assignment of Administration Numbering Plan
1. General
This command is used to assign the minimum number of digits needed to determine the service which is re-
quired to the first digit received (pre-translation).
2. Precautions
1. This command is used for the Hotel Application only.
2. If the Guest and Admin. Numbering are separated (the ASYD command, SYS1, INDEX 160, bit6=0), use
this command for the Admin. Numbering plan.
For the Guest numbering plan, use the AGNP command.
Note: Hotel features are available in TN1 only. If the numbering plans are separated by tenants, the purpose for
each tenant is completely separated.
Admin. Station required of the guest room call must be allocated in TN1.
3. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX 8. Enter
the tenant number in which this command effects.
If data of this command is common for all tenants (ASYD command, SYS1, INDEX 92, bit2=1), assign
TN parameter as data “1” for all tenants.
4. When changing any of the numbering plan data, the old data must be deleted before new data is assigned.
3. Data Entry Instructions
The first digit of station number, service
access code and/or trunk access code, etc.
(0-9, *, #)
1st DC
CI
BLF
1st DIGIT CODE
(1st DC)
TENANT
NUMBER
(TN)
Whether the station busy status is monitored by the system or not.
In Hotel system, assign “0” for this parameter.
NND
CONNECTION STATUS INDEX
(CI)
N/H/B
NUMBER OF NECESSARY DIGITS
(NND)
MAXIMUM 6 DIGITS
BUSY LAMP FIELD
(BLF)
0/1
N=Normal (Idle)
H=Hooking
B=Busy
0=Out of Service 1=In service
The status of the “1st DC” dialed
The primarily analyzed digits, prior to the AASP command.
To assign different number of digits for this, assign minimum
number of digits in this parameter.
0
0
To Next Page
Loading...
Need help?
General