ND-70348 (E) CHAPTER 4
Page 391
Revision 3.0
ARTD
ARTD: Assignment of Route Class Data
1. General
This command is used for the Route Class Data.
2. Precautions
1. The ARTD command should be assigned for all external trunk routes and the dummy route for LCR/LCRS.
2. The applicable number of the external trunk route is designated by the ASYD command, SYS1, INDEX65.
3. The standard route class data is shown in the example. (which is listed after the parameter descriptions)
4. Parameters TCMN through MT are effective only when 4 (MF) is assigned to parameter ONSG or INSG.
For all other trunk routes, assign “0” to all of these data.
3. Data Entry Instructions
See Data Sheet on the following pages. For examples of data assignment, see Table 4-21
(page 407)
.
To Next Page
Loading...
