ND-70348 (E) CHAPTER 4
Page 248
Revision 3.0
ARNPL
ARNPL: Assignment of Reverse Numbering Plan Data for LDM
1. General
This command is used to assign the access code for each individual logical route in accordance with the ARTD/
ARTDN command.
2. Precautions
1. The ARNPL command assignment is required in either of the following cases:
(a) ASPAL/ASPAN command SRV = LCR or SRV= LCRS
(b) ARTD/ARTDN command SMDR = 1 (SMDR is provided)
2. The reversed number (ACC) assigned in this command is output to the SMDR as an access code for the
originating call.
3. The one access code can be entered to different logical routes, however, plural access codes can not be en-
tered to one logical route.
4. When programming the reverse numbering plan data for ISDN/CCIS, assign the B-channel/voice channel
trunk route in the LGRT parameter.
3. Data Entry Instructions
The external trunk route number.
Enter "0" for the self office
identification code for No.7 CCIS.
Enter the ACC.
LGRT
ROUTE
NUMBER
(RT)
ACCESS CODE
(ACC)
MAXIMUM
4 DIGITS
ACC
REMARKS
To Next Page
Loading...
Need help?
General