ND-70348 (E) CHAPTER 1
Page 21
Revision 3.0
INTRODUCTION
CHAPTER 1 INTRODUCTION
1. General
This manual describes how to operate the Maintenance Administration Terminal (MAT) and plan the creation of
the office data. It also contains descriptions of the parameters for PBX.
2. How to Follow This Manual
The contents of this manual are:
• CHAPTER 1 (INTRODUCTION)
This chapter explains how to use this manual.
• CHAPTER 2 (HOW TO OPERATE MAT)
(page 22)
:
This chapter explains the system configuration and system specifications required to install and run the MAT.
It contains installation instructions and information about accelerator keys and navigation keys used by MAT.
• CHAPTER 3 (OFFICE DATA DESIGN SHEET)
(page 49)
:
This chapter contains the office design sheets used to design the configuration and specification of IMX.
• CHAPTER 4 (COMMAND DESCRIPTION AND DATA SHEET)
(page 70)
:
This chapter explains the command parameters of the PBX.
3. Reference Manuals
When installing MAT and assigning the relevant system data, refer to the following manuals in addition to this man-
ual:
• Feature Programming Manual
• Netfusing System Manual
To Next Page
Loading...
Need help?
General