ND-70348 (E) CHAPTER 4
Page 681
Revision 4.0
ALGSN
ALGSN: Allocation of Telephone Station Data for NDM
1. General
This command is used to assign the related data of the Telephone Number (TELN) corresponding to the physical
station. The data assigned by this command is written in Network Data Memory (NDM) of the Network Control
Node (NCN), updating the NDM at each Local Node (LN).
2. Precautions
1. The ALGSN command is used to assign the Telephone Number (TELN) for a Network Control Node
(NCN).
2. The TYPE parameter allows the user to choose the programming method of the physical station.
TYPE = 1 (LENS):Telephone number to be given to the LENS
TYPE = 2 (STN):Telephone number to be given to the station
3. The applicable tenant number (TN) range is designated by the ASYDN command, SYS1, INDEX8. If the
data in this command is common for all tenants (ASYDN, SYS1, INDEX800, bit0 = 1), assign TN param-
eter as “1” for all tenants.
4. When the parameter TYPE is “1” (LENS is used to specify the physical station number), the assignment
of the Fusion Point Code (FPC) entered by the AFMU command is required.
5. For more detail, see the “Netfusing System Manual”.
To Next Page
Loading...
Need help?
General