ND-70348 (E) CHAPTER 4
Page 273
Revision 3.0
AADC
AADC: Assignment of Additional Digit Translation Data
1. General
This command is used to assign additional digit information for LCR (Least Cost Routing).
2. Precautions
1. Before using this command, it must be confirmed that a Pattern Number Location (PNL) has been assigned
in the AOPR command.
2. The applicable number of additional digit (DC) varies depending on the PNL data assigned by the AOPR/
AUNE command. When the AOPR command is assigned, and additional digit is sent to outside of the
Node, a maximum of 4 digits of DC is available when the PNL is assigned with a range from 1 to 127, and
a maximum of 24 digits of DC is available when the PNL is assigned with a range from 128 to 999. When
the AUNE command is assigned, a maximum of 4 digits of DC is available.
3. Data Entry Instructions
Enter DC additional numbers (not including the
access code for LCR) to be applied to the transmitted
number.
DC
Enter the PNL assigned by the AOPR command with a range
1-999, or by the AUNE command with a range 1-127.
PNL
PATTERN NUMBER
LOCATION
(PNL)
1-999
ADDITIONAL DIGIT INFORMATION
(DC)
MAX. 24 DIGITS
REMARKS
To Next Page
Loading...
Need help?
General