ND-70348 (E) CHAPTER 4
Page 585
Revision 3.0
AAND_LR
AAND_LR: Assignment of Automatic Number Identification Data – Logical
Route Number
1. General
This command is used to assign ANI data for the number of digits of calling station number and the office code
on each tenant basis for the Automatic Number Identification (ANI) service (for E911 ANI). Route number of
the AAND command can be assigned by using Logical Route.
2. Precautions
1. Prior to this command, logical route data must be allocated by using the ALRTN command.
2. Only when logging in to the NCN (Network Control Node), this command can be used to assign the logi-
cal route data of self-Node and the other Nodes in the Netfusing Network. If logging in to a LN (Local
Node), data setting only for the self-node is available. (Error message is indicated if you try to write the
data of other Node.)
3. The Route number of RT parameter should have been designated in ARTD, CDN19 ANI = 1.
4. This command is available since Release 9 software enhancement.
3. Data Entry Instructions
Office Code for the number of digits
assigned to parameter ADD.
MAIN/
SATELLITE
CENTRAL
(CC)
EXPANSION
OF STA
NUMBER
LENGTH
(KT)
OFF/ON
LOGICAL
ROUTE
NUMBER
(LGRT)
1-899
FUSION POINT
CODE
(FPC)
1-253
OUTSIDE
ROUTE
NUMBER
(RT)
1-
STA/ATT
OUTGOING
(AT)
AT
DC
• STA outgoing
• ATT outgoing
These parameters vary depending on the
assignment of the previous parameter.
STA
NUMBER
LENGTH
(STNL)
1-8
OFFICE
CODE TO BE
ADDED
(ADD)
1-10
CALL
ORIGINATOR
DIGIT TO BE
SKIPPED
(SKIP)
0-10
OFFICE CODE
(DC)
MAX. 10 DIGITS
[0-9, *, #]
CC
• Main Central
• Satellite Central
CENTRAL OFFICE
CODE
(COC)
MAX. 5 DIGITS
To Next Page
Loading...
Need help?
General