ND-70348 (E) CHAPTER 4
Page 71
Revision 3.0
COMMAND DESCRIPTION AND DATA SHEET
Figure 4-1 Command Descriptions
4.1 Command for Business System
This section explains the command for Business System.
Command name (full name)
The purpose of command and the related servise
feature are explained here.
Peripheral notice necessary to create the office data
which may include the followings;
The related command and parameters
The related service feature
MAT operation instructions
The system hardware operation to be affect the data
The data storage node within the Netfusing network
The required parameters, the applicable data range and
parameter descriptions are explained here.
1. GENERAL
2. PRECAUTIONS
3.DATA ENTRY INSTRUCTIONS
DISP
DISPLAY MESSAGE ON LCD (DISP)FUNCTION KEY CODE (FKY)1-320
FKY FKY
Service name Service name
Default display Default display
AFDD: Assignment of Function Display Data
This command is used to assign the characters of software key indication on a D Series 75.
When this command is not assigned, the default(which shows on FKY parameter description on this command)
are displayed.
The LCD is 24 digits wide, and there are four of software keys, hence a maximum of 6 characters can be assigned
for each software key indication.
Displayed characters (Max.6 characters of alphabet and numbers)
1 FWD-BY
FKY(1-320) Note:The default displayed characters are shown in the parenthesis
1
2
3
4
5
6
7
Call Forwarding-Busy Line
Call Forwarding-All Calls
Executive Right of Way
Call Waiting
CAll Back
-
Save and Repeat
FDB
FDA
BV
CW
CB
-
S&R
-
60
61-82
83
84
85
86
87
Manual Signaling Key
-
Retain Conference
Serial Call
Internal Zone Paging(Not released
for U.S.A.and Canada)
-
Wake Up Set
SIG
-
KEEP
S_CAL
IZP
-
WUS
term
To Next Page
Loading...
Need help?
General