ND-70348 (E) CHAPTER 4
Page 566
Revision 3.0
ADAI
ADAI: Assignment of Terminal Application Data
1. General
This command is used to assign/delete application data for terminals.
2. Precautions
This command is available for Australia only.
3. Data Entry Instructions
a.) When MODE=1 (Station) is assigned:
Note: See
page 569
for other parameters.
MODE
1-3
TENANT
NUMBER
(TN)
STATION
NUMBER
(STN)
Max. 6 Digits
TEST LINE
CIRCUIT
(TLC)
0/1
USER
SPEED
(USPEED)
0-31
STN
Enter the Station Number to which this application
service is applied when "MODE=1" is set.
HOT LINE
(HL)
0/1
INTERMEDIATE
RATE
(IRA)
0-3
ALARM
(ALM)
0/1
MODE
Assign "1".
1 = Station
2 = Trunk
3 = LENS
IRA
Assign Intermediate Rate, based on
the LLC information element within
the range from 0-3.
0 = Not assigned
1 = 8kbps
2 = 16kbps
3 = 32kbps
Assign the User Rate, based on the LLC
(Low Layer Compatibility) information
element (TTC Q931) within the range
from 0~31.
Test Circuit Card
0/1 = Not exist/Exist
TLC
0 = -
1 = Alarm
ALM
Hot Line Recognition
0 = -
1 = Use Hot Line
HL
1
USPEED
Assign the Tenant Number to which
this application service is applied
when "MODE=1" is set.
TN
To Next Page
Loading...
