ND-70348 (E) CHAPTER 4
Page 333
Revision 3.0
ANDD_T
ANDD_T: Assignment of Name Display Data – Telephone Number
1. General
This command is used to assign user information (user’s name) onto a Station to program the Name Display -
System service feature. The station data of ANDD command can be assigned by using Telephone Number.
2. Precautions
1. Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the
ALGSL command is not available in this command.
2. In case logging in to a LN, only the Telephone Numbers allocated to the stations within the logged-in
node can be used in this command. Also, when logging in to the NCN, the data memory of the whole
nodes in the network can be written.
3. The Name Display - System service feature allows a D
term
with LCD to show the user information that
corresponds to the calling station number while it is engaged in a station-to-station call.
4. The ASYD command SYS1, INDEX78, b5=1 (Name Display service) must be set.
5. The number of digit to be assigned to the parameter NAME is determined by the ASYD command, SYS1,
INDEX241, b1=0/1: 8 characters/16 characters. Multi-Line service is not available if “16 characters” is
selected.
6. This command cannot be used for Name Display - OAI service.
7. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX 8.
8. This command is available since Release 8 software enhancement.
3. Data Entry Instruction
Note: The existing data can be readout by pressing “Get” button after UGN and TELN data is entered.
USER
GROUP
NUMBER
(UGN)
TELEPHONE NUMBER
(TELN)
Max. 16 digits
NAME DISPLAY INFORMATION
(NAME)
8 or 16 characters
REMARKS
TELN
Enter the Telephone Number of the station to
which Name Display service is to be applied.
NAME
Enter desired alphanumeric
characters.
To Next Page
Loading...
Need help?
General