ND-70348 (E) CHAPTER 4
Page 531
Revision 3.0
AUOG
AUOG: Assignment of UCD Overflow Group
1. General
This command is used to assign the data related to the Overflow - UCD service feature.
2. Precautions
1. The UCD member station and UCD pilot (controlling station) station should be assigned by the ASHU
command.
2. The calls terminate to the designated group can overflow (forward) to another UCD group. They overflow
from TN-A, STN-A to TN-B, STN-B.
3. The applicable tenant number (TN) range is designated by the ASYD command, SYS 1, INDEX 8.
3. Data Entry Instructions
STATION
NUMBER
(STN-A)
STATION
NUMBER
(STN-B)
REMARKS
TENANT
NUMBER
(TN-A)
TENANT
NUMBER
(TN-B)
TN-B and STN-B
TN-B and STN-B (UCD pilot station number) parameters should be assigned
with respecting to the data assigned by the ASHU command.
TN-A and STN-A
TN-A and STN-A (UCD pilot station number) parameters should be assigned
with respecting to the data assigned by the ASHU command.
ORIGINAL UCD GROUP OVERFLOW UCD GROUP
To Next Page
Loading...
