ND-70348 (E) CHAPTER 4
Page 643
Revision 3.0
AFIP
AFIP: Assignment of Fusion over IP Data for LDM
1. General
This command is used to assign the Router Access Number for controlling voice channel between PBX and
Router.
2. Precautions
1. At the LENS parameter, the information of DTI card used for voice channel is to be assigned.
2. LENS of voice channel must be set on condition that data “2 (=Fusion over IP)” is assigned at CDN16
parameter of ACRD command.
3. This command is available since Release 8 software enhancement.
3. Data Entry Instructions
Note: LENS and RT_ACC parameters are to be adjusted to the ports of the Router.
Line Equipment Number of voice channel.
LENS
FCH
NUMBER
(FCHNO)
1-255
LINE EQUIPMENT
NUMBER OF FGH
(FGHEN)
MG U G LV MG U G LV
LINE EQUIPMENT
NUMBER OF
QSIG-PRIME Bch
(LENS)
ROUTER ACCESS NUMBER
(RT_ACC)
Max. 16 digits
Enter the first Line Equipment Number
of the Group that FGH is assigned.
FGHEN
Assign the Router Access Number to be
recognized by the router.
RT_ACC
FCHNO
Enter the number of FCH.
To Next Page
Loading...
Need help?
General