NEC NEAX 7400 IMX - ACNDN: Assignment of Calling Number Data for NDM

ND-70348 (E) CHAPTER 4
Page 606
Revision 3.0
ACNDN
ACNDN: Assignment of Calling Number Data for NDM
1. General
This command is used to assign the Station Number Identification (SID) sent to the ISDN for the SID To Net-
work - Present service/for the Calling Party Recognition service. The data assigned by this command is written
in Network Data Memory (NDM) of the Network Control Node (NCN), updating the NDM at each Local Node
(LN).
2. Precautions
1. The CNP parameter in this command corresponds to the one assigned by the ACNPN command.
2. Don’t assign the data “0” to both SKIP and ADD parameters.
3. For DC parameter, assign the same number of digits designated at ADD parameter.
4. This command is available since software Release 7 or later.
5. This command must be used in a pair with ACNPN command.
3. Data Entry Instructions
CALLING
NUMBER
PATTERN
(CNP)
0-1023
NUMBER OF DIGITS OF
THE ADDITIONAL
NUMBER
(ADD)
0-24
SKIP DIGIT
(SKIP)
0-24
REMARKS
SKIP
The number of skip digits from the SID.
CNP
0 = OG ID Service
1-1023 = Calling Number Pattern
ADD
The number of the digits for the
additional number.
DIGIT CODE OF
THE ADDITIONAL
NUMBER
(DC)
MAX.24 DIGITS
DC
The SID sent to the ISDN