NEC NEAX 7400 IMX User Manual

ND-70348 (E) CHAPTER 2
Page 45
Revision 3.0
HOW TO OPERATE MAT
7.2 Network Control Node
The following flowchart shows the data assignment for MAT when operated in a Network Control Node environ-
ment.
Figure 2-13 Network Control Node Data Assignment Flow Chart (1/2)
ATIMSystem Base ATIMN ASYD ASYDL ASYDN AUNT AIOC ASTD
AOFC
AUIDN
AFMU
ALRTN
AMND ARNP
ANND ASTP AOSP
ASTPL AOSPL
ASTPN AOSPN
ARNP
ACMO ATCP AFRS AOPR AADC ASDC
AFRSL AOPRL AADCL
AMND ARNP
AUNE
AUNEL
AMND
ALDN ASTP AISP
ASTPL AISPL
ASTPN AISPN
ARAC
ARSC ARRC ATDP
ATDPN
AARP
ATDPL AARPL
AARPN
APCR AEFR
ASFC
ARSCN ARRCN
ACFR ATNR AABD
ANPD ASPA
ANPDL ASPAL
SRV
SRV
STN
TELN
Sys1 Index512 - 1535
Sys1 Index0 - 511 , Sys2 Index0 - 15 & Sys3 Index0 - 31
Station Number
OGC(A)/LCR(S)
Outgoing Call
SSC/SSCA, etc.
SSC
Service / Network
Telephone Number available in the
Self node only
ANPDN ASPAN
SRV
TELN
Telephone Number available in all
nodes of Netfusing Network
Timing Start is available
Numbering Plan
Network Numbering
Restriction
2nd DT(Mark - out) :
Sender :
LCR / LCRS :
Uniform Numbering :
Incoming :
Trunk:
Service:
Sys1 Index0 - 1535
Netfusing Network
Numbering Plan:
Operator Call / OGQ / Priority Call
OGC(A)/LCR(S)
SSCA
Outgoing Call
Call Pickup Expand / UCD BUSY OUT
SSC
Operator Call / Call Pickup Group / OGQ / Priority Call
***
AFRSN AOPRN AADCN
**
*
**
*
**
*
**
*
**
** **
*
**
****
*Note 1: Available for the software Release 3 or later.
**Note 2: Available for the software Release 5 or later.

NEC NEAX 7400 IMX Specifications

General

Brand	NEC
Model	NEAX 7400 IMX
Category	Server
Language	English