ND-70348 (E) CHAPTER 4
Page 332
Revision 3.0
ANDD
ANDD: Assignment of Name Display Data
1. General
This command is used to assign user information (user’s name) onto a Station to program the Name Display -
System service feature.
2. Precautions
1. The Name Display - System service feature allows a D
term
with LCD to show the user information that
corresponds to the calling station number while it is engaged in a station to station call.
2. The following must be set in the ASYD command SYS1, INDEX78, b5 = 1 (Name Display service).
3. The number of digits to be assigned to the parameter NAME is determined by ASYD command, SYS1,
INDEX241, b1=0/1: 8 characters/16 characters. Multi-Line service is not available if “16 characters” is se-
lected.
4. This command cannot be used for “Name Display - OAI” service.
5. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8.
3. Data Entry Instructions
TENANT
NUMBER
(TN)
STATION NUMBER
(STN)
IDENTIFYING
INFORMATION
(NAME)
8 or 16 CHARACTERS
REMARKS
Enter desired alphanumeric character.
NAME
To Next Page
Loading...
