ND-70348 (E) CHAPTER 4
Page 378
Revision 3.0
AIZPN
AIZPN: Assignment of Internal Zone Paging Data for NDM
1. General
This command is used to assign Internal Zone Paging group data in Netfusing Network. The data assigned by
this command is written in the Network Data Memory (NDM) of the Network Control Node (NCN), updating
the NDM at each Local Node (LN).
2. Precautions
1. Each Internal Zone Paging group must be composed of
D
term
station (TEC=12).
2. A maximum of 255 Internal Zone Paging groups can be assigned in one Netfusing Network.
3. A maximum of 24 stations can be assigned to one Internal Zone Paging group.
4. One
D
term
station can be assigned to multiple Internal Zone Paging group.
5. It is not available to arrange the member stations of an Internal Zone Paging group stretching over multi-
ple Nodes.
6. This command is available since Release 9 software enhancement.
3. Data Entry Instructions
Note: The number of digit for Internal Zone Paging group ID is determined by the ASYDL/N SYS1, INDEX804,
b3 0/1: 2 digits/3 digits.
TELEPHONE NUMBER
(TELN)
MAX. 16 DIGITS
NETWORK
INTERNAL
ZONE PAGING
GROUP ID
(NIZPG)
1-255
NIZPG
Enter the Internal Zone Paging group
code in the Netfusing Network with a
range from 1 to 255. Note
TELN
Enter the Telephone Number of the
member stations within Internal
Zone Paging Group.
1
1
UGN
REMARKS
UGN
Fixed to “1.”
To Next Page
Loading...
Need help?
General