NEC NEAX 7400 IMX - ACTKC: Continuous Assignment of Connection Trunk Data for LDM

ND-70348 (E) CHAPTER 4
Page 626
Revision 3.0
ACTKC
ACTKC: Continuous Assignment of Connection Trunk Data for LDM
1. General
This command is used to assign/delete the connection trunk data for B-channel/D-channel route by designating
the range of trunk numbers and LENS.
2. Precautions
1. This command can be used only when the PBX and the MAT are connected in on-line state.
2. Before executing this command, assign the connection route class data using the ACRD command.
3. The available connection route numbers are 1-1023.
4. The available connection trunk numbers are 1-4095.
5. When assigning the information for D-channel, the switch setting of TS on the FCH card is required.
6. This command is available since Release 8 software enhancement.