NEC NEAX 7400 IMX - Local Node;Stand Alone

ND-70348 (E) CHAPTER 2
Page 43
Revision 3.0
HOW TO OPERATE MAT
7.1 Local Node/Stand Alone
The following flow chart shows the data assignment for MAT when operated in a Local Node/Stand Alone envi-
ronment.
Figure 2-12 Local Node/Stand Alone Data Assignment Flow Chart (1/2)
ATIMSystem Base ASYD ASYDL AUNT AIOC ASTD AOFC
AMND ARNP
ANND ASTP AOSP ARNP
ACMO ATCP AFRS AOPR AADC
AFRSL AOPRL AADCL
ASDC
AMND ARNP
AUNE AMND
ARSC ARRC ATDP AARP APCR AEFR
ATDPL AARPL
ASFC ACFR ATNR AABD
ANPD ASPA
ANPDL ASPAL
SRV
SRV
STN
SSC
TELN
Sys1 Index512 - 1535
Sys1 Index0 - 511 , Sys2 Index0 - 15 & Sys3 Index0 - 31
Station Number
Service / Network
Telephone Number available in the Self node only
Timing Start is available
Numbering Plan
Network Numbering
Restriction
2nd DT (Mark - out) :
Sender
LCR / LCRS :
Uniform Numbering :
AUNEL
ALDN ASTP AISP ARAC
Incoming :
Trunk:
Service:
:
Operator Call / OGQ / Priority Call
OGC(A)/LCR(S)
SSC/SSCA, etc.
Outgoing Call
** **
ASTPL AISPL
** **
**Note 1: Available for the software Release 3 or later.
**
** **
ASTPL AOSPL
** **
**