ND-70348 (E) CHAPTER 4
Page 689
Revision 3.0
AFRFL
AFRFL: Assignment of Flexible Route Data for Fusion for LDM
1. General
This command is used to assign the alternative route data via C.O. or tie line used when all the connection trunks
are busy or FCCS link failure (layer 2 down) occurs.
2. Precautions
1. This command is available since the release 5 software.
2. Prior to this command assignment, the following data should be set.
(a) The numbering plan data for the alternative route to be designated here is allowed.
(b) The station-to-station calling activated via FCCS is allowed.
3. Data Entry Instructions
TN
Enter the tenant number
of the calling party.
FPC
Enter the fusion point code
of the terminating node.
ACC
Assign the access code for
the alternative route of
C.O. or tie line.
ACC
MAX. 24 digits
TN
FPC(1-253)
To Next Page
Loading...
Need help?
General