ND-70348 (E) CHAPTER 4
Page 369
Revision 3.0
ADRTN
ADRTN: Assignment of D
term
Display Route Data for NDM
1. General
This command changes the display of trunk class information on the D
term
instead of the Trunk Class (TCL)
designation of the ARTD command.
This data is written in Network Data Memory (NDM) of the Network Control Node (NCN).
2. Precautions
1. The Route Class information is displayed on all D
term
s of all nodes in the Netfusing Network.
2. The data assigned by this command has priority over the data assigned by the ADRTL command.
3. This data is not available for ISDN stations and PS.
4. When a call terminated from the trunk COC number has been assigned by ACOC command, the following
is displayed on the D
term
as to “TYPE” parameter;
• TYPE = 1 (4 characters) is entered, both COC number assigned by ACOC command and 4-character
trunk class assigned at “DISP” parameter is displayed.
• TYPE = 2 (8 characters) is entered, only the 8-character trunk class assigned at “DISP” parameter is
displayed.
3. Data Entry Instructions
The maximum number of characters
1 = 4 (4 bytes ASCII characters)
2 = 8 (8 bytes ASCII characters)
TYPE
Assign Logical Route number at NCN in the Fusion
Network.
LGRT
Logical Route
Number
(LGRT)
1-899
Character
Display Type
(TYPE)
1, 2
Display for Trunk Class on D
term
(DISP)
REMARKS
The characters displayed on the D
term
.
DISP
To Next Page
Loading...
Need help?
General