ND-70348 (E) CHAPTER 4
Page 496
Revision 3.0
ACIC1
ACIC1: Assignment of CIC Code Data 1
1. General
This command is used for CCIS and/or ISDN data programming, and is assigned in the Common Channel Sig-
naling Controller Group (CSCG) for a Destination Point Code (PC).
2. Precautions
1. ACIC2 command assignment is also required for CCIS, and the PC parameter is an intermediate of those
two commands.
2. ACIC2 command is not required for ISDN.
3. The PC parameter should correspond to the data assigned by the ADPC command.
4. The CSCG parameter should correspond to the one assigned by the ACSC command.
5. When this command is used for CCIS, all Point Codes (PC) within the network (except the Originating
Point Code) should be assigned.
3. Data Entry Instructions
1 130
Assign any even number with a range from 2 to 255
(except 128 and 129).
CSCG
DETERMINATE POINT CODE (PC)
1-16383
COMMON CHANNEL SIGNALING CONTROLLER
GROUP NUMBER(CSCG) 2-255
Destination’s Point Code assigned by
the ADPC command and the final
destination’s Point Code in CCIS
network.
PC
To Next Page
Loading...
Need help?
General