ND-70348 (E) CHAPTER 4
Page 760
Revision 3.0
AGSPL
AGSPL: Assignment of Guest Special Access Code for LDM
1. General
This command is used to determine the Kind of Service and the service Access Code to be executed in the Local
Node (LN) on the Netfusing Network.
2. Precautions
1. This command is used for the Hotel Application only.
2. If the Guest and Admin. Numbering are separated (the ASYD command, SYS1, INDEX 160, bit6=0), use
this command for the Guest Special Access code. For the Admin. Special Access code, use the ASPAL
command.
Note: Hotel features are available in TN1 only. If the numbering plans are separated by tenants, the purpose for
each tenant is completely separated. Admin. Station required of the guest room call must be allocated in
TN1.
3. If the numbering plan for Admin. and Guest is common (the ASYD command, SYS1, INDEX 160, bit6=1),
this command may be used to assign the Admin. Special Access code as well.
4. Access Code for Telephone numbers may be programmed by this command, however, those Telephone
numbers are available in the self node only.
Telephone numbers available on the Netfusing Network are to be programmed at Network Control Node
(NCN) by using the AGNPN and AGSPN commands.
To Next Page
Loading...
