ND-70348 (E) CHAPTER 4
Page 274
Revision 3.0
AADCL
AADCL: Assignment of Additional Digit Translation Data for LDM
1. General
This command is used to assign additional digit information for LCR (Least Cost Routing) activating via Net-
fusing Link. This data is written in Local Data Memory (LDM).
2. Precautions
1. Before using this command, it must be confirmed that a Pattern Number Location (PNL) has been assigned
in the AOPRL command.
2. The applicable number of additional digit (DC) varies depending on the PNL data assigned by the AOPRL/
AUNEL command. When the AOPRL command is assigned, and additional digit is sent to outside of the
Node, a maximum of 24 digits of DC is available. When the AUNEL command is assigned, a maximum
of 4 digits of DC is available.
3. Data Entry Instructions
Enter DC additional numbers (not including the
access code for LCR) to be applied to the transmitted
number.
DC
PNL
PATTERN NUMBER
LOCATION
(PNL)
1-999
ADDITIONAL DIGIT INFORMATION
(DC)
MAX. 24 DIGITS
REMARKS
Enter the PNL assigned by the AOPRL command with a range
1-999, or by the AUNEL command with a range 1-127.
To Next Page
Loading...
Need help?
General