ND-70348 (E) CHAPTER 4
Page 485
Revision 3.0
ADPC
ADPC: Assignment of Determinate Point Code Data
1. General
This command is used to assign the destination Point Code (PC) for CCIS and/or the ISDN interface.
2. Precautions
1. A unique PC must be given to a node in the CCIS network. The OPC (Originating Point Code ) is desig-
nated by the ASYD command, SYS1, INDEX180 and 181.
2. The PC is the decimal value from 1 to 16383.
(1-16367 (For CCIS), 1-16383 (For ISDN))
3. An arbitrary PC may be assigned for the ISDN interface, unless the PC is duplicated in the CCIS network.
4. The PC assigned by this command should correspond to the one assigned by the ACIC1/ACIC2 command.
3. Data Entry Instructions
For CCIS, assign the route number of voice route.
For ISDN, assign route numbers of both B-channel route and D-channel route.
ROUTE NUMBER
(RT)
DETERMINATE POINT
CODE (PC) 1-16383
REMARKS
PC (Point Code) for the direct facing office (node) in the CCIS network.
PC
RT
To Next Page
Loading...
