ND-70348 (E) CHAPTER 4
Page 323
Revision 3.0
ASCL
ASCL: Assignment of Station Class Data
1. General
This command is used to change the Telephone Equipment Class (TEC), Route Restriction Class (RSC), and
Service Feature Restriction Class (SFC), without changing the station number.
2. Precautions
1. The station class data (TEC, RSC and SFC) can be changed by the ASCL command, even if the station to
be changed is in busy status. (Conversation is in progress.) When the station becomes idle, the new class
becomes effective.
2. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8.
3. The TEC cannot be changed from a D
term
Class (TEC=12) to any other Telephone Class, or vice versa.
When it is necessary to change the current TEC to another type of TEC, use the ASDT command to delete
the current station data and assign new station data.
4. The RSC corresponds to the ARSC command, and the SFC corresponds to the ASFC command as well.
5. Update the new class data on the data sheet in the ASDT command.
To Next Page
Loading...
Need help?
General