ND-70348 (E) CHAPTER 2
Page 22
Revision 3.0
HOW TO OPERATE MAT
CHAPTER 2 HOW TO OPERATE MAT
1. General
This chapter describes the information needed to install and operate the Maintenance Administration Terminal
(MAT) IMX software.
The IMX MAT software has the following functions:
• Allows user-friendly Graphical User Interface (GUI) with Microsoft Windows 95/NT.
• Provides both an Ethernet interface and a RS232C interface.
• Allows access to a node within the Netfusing Network using a simple Login operation.
• Supports remote maintenance capabilities through a dialup connection.
• Maintains a data entry log when data has been assigned, modified, or deleted.
Note: The recorded log file is a simple text file that can be printed or edited using any Windows application that
supports text file editing.
• Dumps the PBX data into a data file through use of the LIST UP command.
Since the IMX MAT runs on Microsoft’s 32 bit Windows plug-and-play operating system, your peripheral hardware
(Network, Remote Access, Modems, Printer, etc.) is easy to configure. IMX MAT does not require a dedicated
printer. Any printer supported by the operating system, including shared LAN printers, can be used.
2. Getting Started-Hardware
The IMX MAT PC should conform to the specifications explained in this section. The cables, modems, and HUBs
required depend on the connection type.
The IMX MAT allows you to access IMX in the following connection types.
• Serial/direct
• Serial/dialup
• TCP/IP
2.1 PC Specifications
The IMX MAT software requires a PC with the following minimum specifications:
Table 2-1 PC Requirements to Run IMX MAT (Continued)
CPU TYPE Pentium 166 or higher
Memory 32 MB or more for WIN 95 and NT
Hard Disk 500 MB of free space
To Next Page
Loading...
