ND-70348 (E) CHAPTER 4
Page 625
Revision 3.0
ACTK
ACTK: Assignment of Connection Trunk Data for LDM
1. General
This command is used to assign the connection trunk used in the Netfusing link.
2. Precautions
1. Before executing this command, assign the connection route class data using the ACRD command.
2. The available connection route numbers are 1-1023.
3. The available connection trunk numbers are 1-4095.
4. When assigning the information for D-channel, the switch setting of TS on the FCH card is required.
5. For more detailed information, see the “Netfusing System Manual”.
3. Data Entry Instructions
CONNECTION ROUTE
NUMBER (C_RT)
1-1023
CONNECTION TRUNK
NUMBER (C_TK)
1-4095
REMARKS
C_TK
The Connection Trunk controlled
by the connection route.
C_RT
The route assigned for B-channel
and D-channel.
C_LENS
LENS of the trunk for B-channel
and D-channel.
CONNECTION EQUIPMENT NUMBER
(C_LENS)
10
1
0
00
010
To Next Page
Loading...
Need help?
General