ND-70348 (E) CHAPTER 4
Page 287
Revision 3.0
AISP
AISP: Assignment of Incoming Selection Pattern
1. General
This command is used to assign additional digits information with respect to the Incoming Selection Translation
Pattern Number (PNI).
2. Precautions
1. Since the PNI is an intermediate parameter to the ASTP command, assign the PNI for the incoming route
number by the ASTP command before assigning the AISP command.
2. The system processes the ASTP/AISP command prior to the numbering plan data. Thus, if the LCR access
code is added to the received numbers by the ASTP/AISP command, the system processes the LCR related
command such as ASPA/AFRS/AOPR.
3. Data Entry Instructions
Enter the PNI assigned by the ASTP command.
1
PNI
INCOMING SELECTION TRANSLATION PATTERN NUMBER
(PNI)
1-15
ADDITIONAL DIGIT INFORMATION
(DC)
MAXIMUM 4 DIGITS
Enter desired additional numbers within 4 digits.
DC
REMARKS
To Next Page
Loading...
