NEC NEAX 7400 IMX - ASPAL: Assignment of Special Access Code for LDM

ND-70348 (E) CHAPTER 4
Page 239
Revision 3.0
ASPAL
ASPAL: Assignment of Special Access Code for LDM
1. General
This command is used to determine the kind of service and the service Access Code to be executed on the Local
Node (LN) in the Netfusing network.
2. Precautions
1. This command is used for the Business Application.
2. Use this command to assign the operator call and the priority call (terminating to ATT) in the Netfusing
Network when using the software Release 1 or Release 2.
3. Access Code for Telephone numbers may be programmed by this command, however, those Telephone
Numbers are available in the self node only.
Telephone numbers available within the Netfusing Network are to be programmed at Network Control
Node (NCN) by using the ANPDN and ASPAN commands. For more details, see “Netfusing System Man-
ual”.
4. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8. Enter
the tenant number this command affects.
If data of this command is common for all tenants (ASYDL command, SYS1, INDEX800, bit1=1), assign
TN parameter as data “1” for all tenants.