ND-70348 (E) CHAPTER 4
Page 289
Revision 3.0
AISPN
AISPN: Assignment of Incoming Selection Pattern Data for NDM
1. General
This command is used to assign additional digits information with respect to the Incoming Selection Translation
Pattern Number (PNI). The data assigned by this command is written in the Network Data Memory (NDM) of
the Network Control Node (NCN), updating the NDM at each Local Node (LN).
2. Precautions
1. Since the PNI is an intermediate parameter to the ASTPN command, assign the PNI for the incoming route
number by the ASTPN command before assigning the AISPN command.
2. The system processes the ASTPN/AISPN command prior to the numbering plan data. Thus, if the LCR
access code is added to the received numbers by the ASTPN/AISPN command, the system processes the
LCR related command such as ASPAN/AFRSN/AOPRN.
3. Data Entry Instructions
Enter the PNI assigned by the ASTPN command.
1
PNI
INCOMING SELECTION TRANSLATION PATTERN NUMBER
(PNI)
1-15
ADDITIONAL DIGIT INFORMATION
(DC)
MAXIMUM 4 DIGITS
Enter desired additional numbers within 4 digits.
DC
REMARKS
To Next Page
Loading...
Need help?
General