NEC NEAX 7400 IMX - ACBC: Assignment of Call by Call Service Data

ND-70348 (E) CHAPTER 4
Page 611
Revision 3.0
ACBC
ACBC: Assignment of Call by Call Service Data
1. General
This command is used to assign the Call by Call Information for an ISDN Network.
2. Precautions
1. Before assigning data, assign the Outgoing Route Selection Pattern Number (OPR) using the AOPR com-
mand.
2. The applicable data assignment for each ISDN switch is listed below.
3. The data assignment of the INTF parameter of this command should correspond to the INT parameter of
the ARTD command.
4. The data assignment of the TON parameter of this command should correspond to the one assigned by the
ARTI command.
Table 4-28 Data Assignments for ISDN Switch
ACBC
AT&T NT
Feature Access
Service Access
(SDN)
Service Access
(MEGACOM, etc.)
Public, etc. Public, etc.
TDPTN 0 - 7 0 - 7 0 - 7 0 - 7 0 - 7
OPR 0 - 4095 0 - 4095 0 - 4095 0 - 4095 0 - 4095
RA 0 - 7 0 - 7 0 - 7 0 - 7 0 - 7
MD 0 0 0 0 0
TON 1 / 2 1 / 2 1 / 2 1 / 2 1 / 2
INTF 5 5 5 7 7
SERV 0 1 1 0 0
CODE 0 / 5 / 6 1 2 / 3 / 5 / 6 0 / 1 / 2 / 4 / 5 / 8 3
BAND - 0 - 9 - - 0 - 9
SCC 3 digits 3 digits - - -