NEC NEAX 7400 IMX - AISD_T: Assignment of Individual Speed Calling Data - T.number

ND-70348 (E) CHAPTER 4
Page 551
Revision 3.0
AISD_T
AISD_T: Assignment of Individual Speed Calling Data – Telephone Number
1. General
This command is used to assign the speed dial number (of the Speed Calling - Station service feature) for a sta-
tion, instead of a station user’s registration. The station data of AISD command can be assigned by using Tele-
phone Number.
2. Precautions
1. Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the
ALGSL command is not available in this command.
2. In case logging in to a LN, only the Telephone Numbers allocated to the stations within the logged-in
node can be used in this command. Also, when logging in to the NCN, the data memory of the whole
nodes in the network is to be written.
3. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX 8.
4. The Station designated by Telephone Number on this command should be assigned as a master station
(MST) by the AISA/AISA_T command beforehand.
5. The data range of the SPD parameter on this command varies depending on the number of memory-
blocks assigned by the AISA/AISA_T command. (One memory-block contains ten memories which store
ten different speed dialing numbers.)
6. This command is available since Release 8 software enhancement.
3. Data Entry Instruction
Note: The existing data can be readout by pressing “Get” button after UGN and TELN data is entered.
USER
GROUP
NUMBER
(UGN)
SPEED
CALLING
DIGIT CODE
(SPD)
00-99
TELEPHONE NUMBER
(TELN)
Max. 16 digits
TELEPHONE NUMBER
(TEL)
Max. 24digits
TELN
Assign the Telephone Number designated
as a Master Station (Station Type = MST)
by the AISA/AISA_T command.
TEL
The dial number to be transmitted by the
system when a station user dial Speed
Calling — Station access code + SPD.
SPD
When assigning the parameter BLOCK=1 in the
AISA/AISA_T command, assign any data in the
range of 00-09 to this parameter.
When assigning the parameter BLOCK=2 in the
AISA/AISA_T command, assign any data in the
range of 00-19 to this parameter.