ND-70348 (E) CHAPTER 4
Page 642-2
Revision 5.0
AVIPS
AVIPS: Assignment of VoIP-PKG detailed Data with Software
1. General
This command is used to assign/delete the detailed data of IPTRK card such as Jitter Buffer, Payload Type/Size,
FAX mode by software. The data can be assigned on a circuit basis by specifying the LENS. The detailed data
is categorized in the following two types:
i. Voice Data (for FCCS/CCIS/H.323)
ii. Signal Data (for H.323 only)
2. Precautions
1. AVIPS and AGIP commands cannot be used simultaneously.
2. IPTRK related data specified by the LENS must be assigned by the AGIP command in advance.
3. The assignment on this command has priority over the switch setting on the IPTRK card.
4. This command is available since Release 10 software enhancement for IPX only.
3. Data Entry Instructions
* Continued on the next page.
KIND OF
SELECTION
(KIND)
LINE
EQUIPMENT
NUMBER
(LENS)
MG U G
LENS
Enter the LENS of IPTRK
(PA-16IPTC) card.
The kind, IPTRK (FCCS), IPTRK (CCIS), or
IPTRK (H.323), assigned by the AGIP command
is displayed. (Display only. It cannot be modified
here.)
KIND
To Next Page
Loading...
Need help?
General