ND-70348 (E) CHAPTER 4
Page 374
Revision 3.0
ADIM
ADIM: Assignment of Dial Intercom Data
1. General
This command is used to assign Dial Intercom service related data.
2. Precautions
1. For providing Dial Intercom Service, it is necessary to assign the following data in advance:
ASYD command, SYS1, Index 59, b7 = 1
2. The number of D
term
stations that can be accommodated in a Dial Intercom Group and also the number of
digits for Call Number (Dial Intercom STN) are determined by parameter N (Dial Intercom Digit Number).
3. When N= 0 is entered, a maximum of 10 Intercom Station Numbers can be assigned.
When N=1 is entered, a maximum of 64 Intercom Station Numbers can be assigned.
4. The applicable tenant number (TN) range is designated by the ASYD command, SYS 1, INDEX 8.
5. Enter “My Line” Station Number of D
term
in the “ICMSTN” (Dial Intercom Station Number) parameter.
6. Compose a Dial Intercom Group with D
term
stations of the same TN (Tenant Number) under the same MG
(Module Group).
7. From 1 to 50 Dial Intercom Groups can be composed on each MG (Module Group) basis.
8. An Intercom member can override another Intercom station in a two-party Intercom connection. This kind
of overriding is referred to as INTERCOM BRIDGE.
3. Data Entry Instructions
0=one digit (0-9)
1=two digits(00-63)
0
1
N
MODULE
GROUP
NUMBER
(MG No.)
GROUP
ID
NUMBER
(G-ID)
1-50
DIAL INTERCOM
DIGIT
NUMBER
(N)
0/1
BRIDGE
CALL
RESTRIC-
TION(BCR)
0/1
TENANT
NUMBER
(TN)
REMARKS
REMARKS
INTERCOM STATION
NUMBER (ICM STN)
ICMCTICMCT
INTERCOM STATION
NUMBER (ICM STN)
0=Restricted
1=Allowed
BCR
5
6
To Next Page
Loading...
