ND-70348 (E) CHAPTER 4
Page 534
Revision 3.0
AUAD
AUAD: Assignment of UCD Delayed Announcement Data
1. General
This command is used to assign the data related to the Delay Announcement - UCD service feature.
2. Precautions
1. The UCD member station and UCD pilot (controlling station) station should be assigned by the ASHU
command.
2. A maximum of eight (8) external announcement machines can be assigned per a UCD group.
3. As to the designation of sharing the UCD Announcement Information (ASYD, SYS1, INDEX7, bit6: 0/1
= Common/per UCD group), be sure to follow as mentioned below;
• In case the system data (ASYD, SYS1, INDEX70, bit6) shall be modified after the UCD Announce-
ment Information has already been assigned, first clear all the data assigned by this command (AUAD),
then the new data is to be reassigned.
4. The applicable tenant number (TN) range is designated by the ASYD command, SYS 1, INDEX 8.
To Next Page
Loading...
Need help?
General