ND-70348 (E) CHAPTER 4
Page 288
Revision 3.0
AISPL
AISPL: Assignment of Incoming Selection Pattern Data for LDM
1. General
This command is used to assign additional digits information with respect to the Incoming Selection Translation
Pattern Number (PNI). This data is written in Local Data Memory (LDM).
2. Precautions
1. Since the PNI is an intermediate parameter to the ASTPL command, assign the PNI for the incoming route
number by the ASTPL command before assigning the AISPL command.
2. The system processes the ASTPL/AISPL command prior to the numbering plan data. Thus, if the LCR ac-
cess code is added to the received numbers by the ASTPL/AISPL command, the system processes the LCR
related command such as ASPAL/AFRSL/AOPRL.
3. Data Entry Instructions
Enter the PNI assigned by the ASTPL command.
1
PNI
INCOMING SELECTION TRANSLATION PATTERN NUMBER
(PNI)
1-15
ADDITIONAL DIGIT INFORMATION
(DC)
MAXIMUM 4 DIGITS
Enter desired additional numbers within 4 digits.
DC
REMARKS
To Next Page
Loading...
Need help?
General