NEC NEAX 7400 IMX - ACPGN: Assignment of Call Pickup Group for NDM

ND-70348 (E) CHAPTER 4
Page 542
Revision 3.0
ACPGN
ACPGN: Assignment of Call Pickup Group for NDM
1. General
This command is used to assign Call Pickup Group for Netfusing Service. The data assigned by this command
is written in the Network Data Memory (NDM) of the Network Control Node (NCN), updating the NDM at
each Local Node (LN).
2. Precautions
1. The maximum number of member stations within each Call Pickup Group is 100.
2. The access code of the Call Pickup Group is assigned by the ASPAN command SSC, SID=7.
3. There is no limitation in a CALL Pickup Groups within a system.
4. The station can be assigned to only one Call Pickup Group.
5. Either Call Pickup Group for LDM or Call Pickup Group for NDM can be executed in a system. (Both ser-
vices can’t coexist in a system.)
3. Data Entry Instructions
Note: Enter the Telephone Number to be assigned in “EDIT TELN” box on the display.
NUMBER
OF
STATIONS
(CNT)
NUMBER
OF
STATIONS
(CNT)
USER GROUP NUMBER
(UGN)
TELEPHONE NUMBER
(TELN)
TELEPHONE
NUMBER
(TELN)
TELEPHONE
NUMBER
(TELN)
TELEPHONE
NUMBER
(TELN)
TELEPHONE
NUMBER
(TELN)
NUMBER
OF
STATIONS
(CNT)
NUMBER
OF
STATIONS
(CNT)
TELN
Assign a Telephone Number of the member station
2
3
27
28
52
53
77
78
UGN
Fixed to 1