ND-70348 (E) CHAPTER 4
Page 247
Revision 3.0
ARNP
ARNP: Assignment of Reverse Numbering Plan Data
1. General
This command is used to assign the access code for each individual route in accordance with the ARTD com-
mand.
2. Precautions
1. The ARNP command assignment is required in either of the following cases:
(a) ASPA command SRV = LCR or SRV= LCRS
(b) ARTD command SMDR = 1 (SMDR is provided)
2. The reversed number (ACC) assigned in this command is output to the SMDR as an access code for the
originating call.
3. The one access code can be entered to different routes, however, plural access codes can not be entered to
one route.
4. If Centralized Billing-CCIS, Call Back-CCIS and Calling/Called Number Display-CCIS service is provid-
ed in the Open Numbering Network, the following data should be assigned:
RT = 0
ACC = The Office Code of the self office (including ACC for the originating call)
5. When programming the reverse numbering plan data for ISDN/CCIS, assign the B-channel/voice channel
trunk route in the RT parameter.
3. Data Entry Instructions
The external trunk route number.
Note: Enter "0" for the self
office identification code
for No.7 CCIS.
Enter the ACC.
RT
ROUTE
NUMBER
(RT)
ACCESS CODE
(ACC)
MAXIMUM
4 DIGITS
ACC
REMARKS
To Next Page
Loading...
Need help?
General