ND-70348 (E) CHAPTER 4
Page 593
Revision 3.0
ACFO
ACFO: Assignment of Call Forwarding Data
1. General
This command is used to assign various call forwarding service data, on a tenant basis. Note that the destinations
of forwarded calls can be the attendant console, a station or an outside party.
2. Precautions
1. The parameter“ADC”is only displayed when designating 4 to the“CFI”. The Abbreviated Digit Codes
(ADC) and the speed dial number are assigned by the ASPD command.
2. The applicable tenant number (TN) range is designated by the ASYD command, SYS 1, INDEX 8. If data
of this command is common for all tenants (ASYD command, SYS1, INDEX 93, bit1=1), assign TN pa-
rameter as data “1” for all tenants.
3. Data Entry Instructions
NUMBER
(TN)
TENANT
REMARKS
CALL FORWARDING
SERVICE
(CF)
CALL FORWARDING
DESTINATION
AND STATION NUMBER
(CFI)
1/2
(STN)
ABBREVIATED DIGIT
CODE
(ADC)
MAX.4 DIGITS
CFI
CF
ADC
STN
1 = Attendant Console
2 = Station
The "STN" parameter appears when
data is entered in the CFI parameter.
1 = C.F. - Busy Line
2 = C.F. - Don't Answer
3 = C.F. - Intercept
4 = Night Connection Outside
The parameter "ADC" is displayed when data
"1" is entered in the CFI parameter.
1-4
1
2
3
4
To Next Page
Loading...
Need help?
General