ND-70348 (E) CHAPTER 4
Page 582
Revision 3.0
ATAS
ATAS: Assignment of TAS Service Data
1. General
This command is used to assign the data related to the Trunk Answer From Any Station (TAS) service feature.
2. Precautions
1. One tenant can be provided one TAS indicator.
2. The TAS answer access code is assigned by the ASPA command, SRV=SSC, SID=16.
3. The TAS answering capability is assigned by the ASFC command, SFI=13 and the ACFR command, TS-
FI=5.
4. The applicable tenant number (TN) range is designated by the ASYD command, SYS 1, INDEX 8. If data
of this command is common for all tenants (ASYD command, SYS1, INDEX 93, bit2=1), assign TN pa-
rameter as data “1” for all tenants.
3. Data Entry Instructions
TENANT NUMBER
(TN)
UNIT NUMBER
(UNIT)
0-3
MODULE GROUP
NUMBER
(MG)
CIRCUIT NUMBER
(CN)
0/1
REMARKS
TN
Enter the tenant number to be applied to the TAS
service.
UNIT
Enter the Unit number the TAS indicator.
CN
MG
Enter the circuit number of the TAS indicator.
Enter the module Group number the TAS
indicator is mounted.
To Next Page
Loading...
Need help?
General