ND-70348 (E) CHAPTER 4
Page 743
Revision 3.0
AGNPL
AGNPL: Assignment of Guest Numbering Plan for LDM
1. General
This command is used to assign the minimum number of digits needed to determine the service which is re-
quired to the first digit received (pre-translation).
2. Precautions
1. This command is used for the Hotel Application.
2. If the Guest and Admin. Numbering are separated (the ASYD command, SYS1, INDEX 160, bit6=0), use
this command for the Guest Numbering plan. For the admin. numbering plan, use the ANPDN command.
Note: Hotel features are available in TN1 only. If the numbering plans are separated by tenants, the purpose for
each tenant is completely separated.
Admin. Station required of the guest room call must be allocated in TN1.
3. Use this command to assign the numbering data for the operator call and the priority call (terminating to
ATT) in the Netfusing Network.
4. The numbering data for Telephone numbers may be programmed by this command, however, those Tele-
phone numbers are available in the self node only.
Telephone numbers available within the Netfusing Network are to be programmed at Network Control
Node (NCN) by using the AGNPN and AGSPN commands.
5. The system data assignment (ASYDL, SYS1, INDEX 513, bit0=1) is necessary for using the AGNPL com-
mand.
To Next Page
Loading...
Need help?
General