ND-70348 (E) CHAPTER 4
Page 767
Revision 3.0
AGSPN
AGSPN: Assignment of Guest Special Access Code for NDM
1. General
This command is used to assign the numbering plan data of the Network Control Node (NCN). The data as-
signed on this command is written in the Network Data Memory (NDM) of the Network Control Node (NCN),
updating the NDM at each Local Node (LN).
2. Precautions
1. This command is used for the Hotel Application only.
2. If the Guest and Admin. Numbering are separated (the ASYD command, SYS1, INDEX 160, bit6=0), use
this command for the Guest Special Access code. For the Admin. Special Access code, use the ASPAN
command.
Note: Hotel features are available in TN1 only. If the numbering plans are separated by tenants, the purpose for
each tenant is completely separated. Admin. Station required of the guest room call must be allocated in
TN1.
3. If the numbering plan for Admin. and Guest is common (the ASYD command, SYS1, INDEX 160, bit6=1),
this command may be used to assign the Admin. Special Access code as well.
To Next Page
Loading...
Need help?
General