ND-70348 (E) CHAPTER 4
Page 688
Revision 3.0
AMWF
AMWF: Assignment of Message Waiting Remote FPC for LDM
1. General
This command is used to assign FPC (Fusion Point Code) of Remote nodes in the Netfusing Network for Mes-
sage Waiting control.
2. Precautions
1. This data is necessary at the center node having Message Center Interface.
2. This command is available in the software Release 2 or later.
3. Data Entry Instructions
Remote FPC
Assignment
Number (CNT)
0-252
Remote FPC for
Message Waiting
Function Control
(REMOTE FPC)
1-253
FPC of Self Node
(CENTER FPC)
1-253
REMARKS
This parameter is for display only.
CENTER FPC
Enter FPC of Remote node to each CNT.
REMOTE FPC
0
1
2
To Next Page
Loading...
