ND-70348 (E) CHAPTER 4
Page 563
Revision 3.0
ASLU1_T
ASLU1_T: Assignment of Slumber Time Data 1 – Telephone Number
1. General
This command is used to assign the data related to the Slumber Time - Do Not Disturb service feature. The sta-
tion data of ASLU1 command can be assigned by using Telephone Number.
2. Precautions
1. Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the
ALGSL command is not available in this command.
2. In case logging in to a LN, only the Telephone Numbers allocated to the stations within the logged-in
node can be used in this command. Also, when logging in to the NCN, the data memory of the whole
nodes in the network is to be written.
3. The call terminated to the slumber group is forwarded to an Attendant Console or an Announcement trunk
(DAT circuit card) with a predetermined slumber time.
4. The Telephone Number of the station belongs to the slumber group is assigned by this command.
5. The slumber time period and the forwarded destination are assigned by the ASLU2 command.
6. The “G” parameter on this command is intermediate data to assign the ASLU2 command.
7. Denial of the Slumber Time - Do Not Disturb service feature can be assigned by either of the following
commands:
(a) ARTD command, SLOV=1 is assigned for trunk route
(b) ASFC command, SFI=107, RES=1 is assigned for the class of the originating station
8. This command is available since Release 8 software enhancement.
3. Data Entry Instruction
Note: The existing data can be readout by pressing “Get” button after UGN and TELN data is entered.
USER
GROUP
NUMBER
(UGN)
SLUMBER
GROUP
NUMBER
(G)
1-7
TELEPHONE NUMBER
(TELN)
Max. 16 digits
REMARKS
TELN
Enter the Telephone Number of the
station which belongs to the Slumber
Group.
G
Assign the Slumber Group Number for the
station designated by "TELN" parameter.
Multiple numbers of station can be assigned
to a slumber group number.
To Next Page
Loading...
Need help?
General