ND-70348 (E) CHAPTER 4
Page 256
Revision 3.0
AOSPN
AOSPN: Assignment of Outgoing Selection Pattern for NDM
1. General
This command is used to assign skip and additional digits information for Outgoing Selection Translation Pat-
tern Number (PNO) in Netfusing System. The data assigned by this command is written in the Network Data
Memory (NDM) of the Network Control Node (NCN), updating the NDM at each Local Node (LN).
2. Precautions
1. Before using this command, make sure that an Outgoing Selection Translation Pattern Number (PNO) has
been assigned in the ASTPN command.
2. The transmit number translation of the OGC/OGCA method outgoing calls are done by ASTPN/AOSPN
command. Since the additional number and skip digits can be assigned by the AOPRN/AADCN command
for LCR/LCRS method, the ASTPN/AOSPN command may not be required.
3. Data Entry Instructions
Enter the PNO assigned by the ASTPN command.
PNO
NUMBER OF DIGITS
SKIPPED
(SKIP)
0-24
NUMBER OF ADDITIONAL
DIGITS
(ADD)
0-4
ADDITIONAL DIGIT INFORMATION
(DC)
MAXIMUM 4 DIGITS
OUTGOING SELECTION
TRANSLATION PATTERN NUMBER
(PNO)
1-15
Enter the number of digits to be entered in DC parameter.
If SKIP=0, ADD must be assigned to 1-4.
ADD
SKIP DC
Enter desired skip digits if required
Enter desired additonal numbers within 4 digits.
To Next Page
Loading...
Need help?
General