ND-70348 (E) CHAPTER 4
Page 251
Revision 3.0
ASTP
ASTP: Assignment of Signal Translation Pattern
1. General
This command is used to assign the Incoming/Outgoing Selection Translation Pattern Number (PNI/PNO) for
incoming or outgoing trunk route.
2. Precautions
1. The PNI/PNO is an intermediate parameter to assign additional number (and skip digits) by the AISP/
AOSP command.
(a) When IC/OG=I (Incoming) is entered, the additional number is assigned by the AISP command.
(b) When IC/OG=O (Outgoing) is entered, the additional number and skip digits are assigned by the
AOSP command.
2. The transmit number translation of the OGC/OGCA method outgoing calls are done by ASTP/AOSP com-
mand. Since the additional number and skip digits can be assigned by the AOPR /AADC command for
LCR/LCRS method, the ASTP/AOSP command may not be required.
3. The system processes ASTP/AISP command prior to the numbering plan data. Thus, if the LCR access
code is added to the received numbers by the ASTP/AISP command, the system processes the LCR related
command such as ASPA/AFRS /AOPR.
4. The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8. Enter
the tenant number in which this command effects. If data of this command is common for all tenants
(ASYD command, SYS1, INDEX93, bit4,5=1), assign TN parameter as data “1” for all tenants.
3. Data Entry Instructions
PNI appears when IC/OG=I is entered. Enter any number with
a range from 1 to 15.
I=Incoming
O=Outgoing
PNI
IC/OG
KIND OF
ASSIGNMENT
(IC/OG)
I/O
TENANT
NUMBER
(TN)
ROUTE
NUMBER
(RT)
INCOMING SELECTION
TRANSLATION
PATTERN NUMBER
(PNI)
1-15
OUTGOING SELECTION
TRANSLATION
PATTERN NUMBER
(PNO)
1-15
pnip
PNO
I1001 1
PNO is appeared when IC/OG=O is entered. Enter any number
with a range from 1 to 15.
PNO
To Next Page
Loading...
Need help?
General