ND-70348 (E) CHAPTER 4
Page 217
Revision 3.0
AUNT
AUNT: Assignment of Unit Data
1. General
This command assigns the Unit data. It also assigns miscellaneous circuit cards to be mounted in LPM.
2. Precautions
• Prior to assigning the number of unit data using this command, the ASYD command should be properly as-
signed.
• The applicable data range in the Module Group Number (MG) parameter is designated by the ASYD com-
mand, SYS1, INDEX 0
(page 82)
.
• Since the PFT is a mechanical action circuit, the PFT operates properly without any data assignment. How-
ever, if the "PFT control by external key" is required, the following data assignments are needed:
(a) AUNT command, TYPE=2 (PFT)
(b) AEKD command
(c) ANCD command
• If the number of the unit’s data deletion is required, you should clear all the station/trunk data within the unit
by using the ASDT/ATRK commands.
To Next Page
Loading...
