ND-70348 (E) CHAPTER 4
Revision 5.0
ALGDN
ALGDN: Assignment of Login Grade Data for NDM
1. General
This command is used to assign the usable commands according to the Login Grade of each user within Fusion
network. Judging from the grade of each User ID, usable commands are restricted. The data assigned by this
command is written in the Network Data Memory (NDM) of the Network Control Node (NCN), updating the
NDM at each Local Node (LN).
2. Precautions
1. The AUIDN command determines the Login Grade for each User ID.
2. Maximum of 32 commands can be assigned as the usable command to each Login Grade.
3. This command is available for the software Release 11 or later.
3. Data Entry Instructions
Note:
Click the “Get” button to read out the registered data. In case no data exists, after the message box “No
data has been assigned” appears, the data previously written/read out is displayed on the command list.
LOGIN
GRADE
(GRADE)
1-16
COMMANDCNT
25
26
27
17
18
19
9
1010
11
1 ASDT
AKYD2
3
GRADE
Enter the grade in the range of 1-16.
COMMAND
Designate the command name in “COMMAND” field on
the MAT screen to register the usable commands for each
Login Grade. Maximum 32 commands can be assigned per
grade depending on the logged-in user.
COMMANDCNTCOMMANDCNTCOMMANDCNT
Page 228-2
To Next Page
Loading...
Need help?
General